I think a better change is to use the ret variable, like this
--- a/drivers/fpga/dfl-pci.c
+++ b/drivers/fpga/dfl-pci.c
@@ -312,7 +312,7 @@ static int cci_pci_sriov_configure(struct pci_dev *pcidev,
int num_vfs)
}
}
- return num_vfs;
+ return ret;
}
The existing use of returning num_vfs is not right, the function should return
0/err not num_vfs. currently it is reusing the 0 passed in with num_vfs to mean
disable as the 0 return status. it should be properly returning ret.
Tom
On 7/9/20 1:12 AM, Xu Yilun wrote:
> This is to fix lkp cppcheck warnings:
>
> drivers/fpga/dfl-pci.c:230:6: warning: The scope of the variable 'ret' can
> be reduced. [variableScope]
> int ret = 0;
> ^
>
> drivers/fpga/dfl-pci.c:230:10: warning: Variable 'ret' is assigned a value
> that is never used. [unreadVariable]
> int ret = 0;
> ^
>
> Fixes: 3c2760b78f90 ("fpga: dfl: pci: fix return value of
> cci_pci_sriov_configure")
> Reported-by: kbuild test robot <[email protected]>
> Signed-off-by: Xu Yilun <[email protected]>
> Acked-by: Wu Hao <[email protected]>
> ---
> drivers/fpga/dfl-pci.c | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/fpga/dfl-pci.c b/drivers/fpga/dfl-pci.c
> index 4a14a24..73b5153 100644
> --- a/drivers/fpga/dfl-pci.c
> +++ b/drivers/fpga/dfl-pci.c
> @@ -285,7 +285,6 @@ static int cci_pci_sriov_configure(struct pci_dev
> *pcidev, int num_vfs)
> {
> struct cci_drvdata *drvdata = pci_get_drvdata(pcidev);
> struct dfl_fpga_cdev *cdev = drvdata->cdev;
> - int ret = 0;
>
> if (!num_vfs) {
> /*
> @@ -297,6 +296,8 @@ static int cci_pci_sriov_configure(struct pci_dev
> *pcidev, int num_vfs)
> dfl_fpga_cdev_config_ports_pf(cdev);
>
> } else {
> + int ret;
> +
> /*
> * before enable SRIOV, put released ports into VF access mode
> * first of all.
