On Mon, 18 Jun 2018 22:41:03 +0200, Martin Kaiser <[email protected]> wrote:
> The v21 version of the NAND flash controller contains a Spare Area Size > Register (SPAS) at offset 0x10. Its setting defaults to the maximum > spare area size of 218 bytes. The size that is set in this register is > used by the controller when it calculates the ECC bytes internally in > hardware. > > Usually, this register is updated from settings in the IIM fuses when > the system is booting from NAND flash. For other boot media, however, > the SPAS register remains at the default setting, which may not work for > the particular flash chip on the board. The same goes for flash chips > whose configuration cannot be set in the IIM fuses (e.g. chips with 2k > sector size and 128 bytes spare area size can't be configured in the IIM > fuses on imx25 systems). > > Set the SPAS register explicitly during the preset operation. Derive the > register value from mtd->oobsize that was detected during probe by > decoding the flash chip's ID bytes. > > While at it, rename the define for the spare area register's offset to > NFC_V21_RSLTSPARE_AREA. The register at offset 0x10 on v1 controllers is > different from the register on v21 controllers. > > Signed-off-by: Martin Kaiser <[email protected]> > Cc: [email protected] > Fixes: d484018 ("mtd: mxc_nand: set NFC registers after reset") Reviewed-by: Miquel Raynal <[email protected]> Thanks, Miquèl
