On Tue, Mar 11, 2008 at 12:38 AM, Michael Krufky <[EMAIL PROTECTED]> wrote:
> Jarryd Beck wrote:
> >> I think that the tda18271 driver will work with your tuner, but we may
> >> need to make some small adjustments. If you look in tda18271-fe.c ,
> >> you'll find the code that autodetects between a TDA18271c1 and a
> >> TDA18271c2 ...
> >>
> >
> > [snip]
>
> >
> > Also if I could somehow get this working with the right
> > code, I don't know how to set up the values in the tda182171_config
> > struct.
> >
>
> Jarryd,
>
> Assuming that there is no tda829x analog demod present, and that this is
> a digital-only device, try something like this:
>
> static struct tda18271_config jarryd_tda18271_config = {
> .gate = TDA18271_GATE_DIGITAL
> }
>
>
> You should leave .std_map as NULL unless you need to override the default
> values per standard.
>
> The value in the ".std_bits" corresponds to the lower five bits in EP3
> (register 0x05 [4:0])
>
> Most likely, the driver's default setting will work for you, but you
> may find that the vendor chose a different value if you sniff the usb
> traffic from the windows driver. This value is directly tied to the IF
> frequency between the tuner and demod.
>
> -Mike Krufky
>
>
That didn't work, the problem is I can't tell where it's going wrong and
I don't understand usb sniffs. I have a few questions:
When af9015 reads the tuner, the existing tuners set the spectral
inversion state->gpio3. Do you know what state->gpio3 does?
The code then goes on to read the spectral inversion, but there's
a comment there saying it's always 0, and the existing tuners
have theirs set to 1, what should I set it to for this one?
If it's the case that some of the other values in the config are wrong,
how would I go about making sense of a usb sniff?
Jarryd.
_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
