Christopher, with 3.18-vivid (3.18.0-031800_3.18.0-031800.201412071935):
The good news is that thunderbold-ethernet is plug and play (no longer needs to reboot with thunderbold plugged in). Unplugging it and plugging it again works too: fully plug and play. The bad news is that the computer cannot suspend at all: A. When using the top-right power button and choosing suspend, the screen goes dark but quickly brightens. B. When closing the lid, the screen remains dark but it is actually not suspended (can been seen in dmesg). All 4 CPUs are recognized after the first reboot--but this was the case before too. Don't know what will happen in the next reboot. The dmesg (attached) contains, in this order, the normal boot sequence, one attempt to suspend from the power menu, and one attempt to suspend by closing the lid, and the plug-and-play action of the thunderbold- ethernet adapter. The relevant part of dmesg from the point in time when I initiated the suspend sequence by lowering the lid (notice the ERROR): [ 114.901412] PM: Syncing filesystems ... done. [ 114.907053] PM: Preparing system for mem sleep [ 114.907164] Freezing user space processes ... (elapsed 0.617 seconds) done. [ 115.523970] Freezing remaining freezable tasks ... (elapsed 0.001 seconds) done. [ 115.525235] PM: Entering mem sleep [ 115.525263] Suspending console(s) (use no_console_suspend to debug) [ 115.525651] [drm:intel_uncore_check_errors] *ERROR* Unclaimed register before interrupt [ 115.525743] sd 0:0:0:0: [sda] Synchronizing SCSI cache [ 116.700502] sd 0:0:0:0: [sda] Stopping disk [ 116.730544] PM: suspend of devices complete after 1206.337 msecs [ 116.778370] PM: late suspend of devices complete after 47.867 msecs [ 116.778609] thunderbolt 0000:07:00.0: suspending... [ 116.779236] xhci_hcd 0000:00:14.0: System wakeup enabled by ACPI [ 116.779247] thunderbolt 0000:07:00.0: stopping RX ring 0 [ 116.779251] thunderbolt 0000:07:00.0: disabling interrupt at register 0x38200 bit 12 (0x1001 -> 0x1) [ 116.779256] thunderbolt 0000:07:00.0: stopping TX ring 0 [ 116.779259] thunderbolt 0000:07:00.0: disabling interrupt at register 0x38200 bit 0 (0x1 -> 0x0) [ 116.779262] thunderbolt 0000:07:00.0: control channel stopped [ 116.779263] thunderbolt 0000:07:00.0: suspend finished [ 116.794430] PM: noirq suspend of devices complete after 16.074 msecs [ 116.794701] ACPI: Preparing to enter system sleep state S3 [ 116.826297] PM: Saving platform NVS memory [ 116.826298] Disabling non-boot CPUs ... [ 116.826331] intel_pstate CPU 1 exiting [ 116.827460] kvm: disabling virtualization on CPU1 [ 116.827464] smpboot: CPU 1 is now offline [ 116.827752] intel_pstate CPU 2 exiting [ 116.828885] kvm: disabling virtualization on CPU2 [ 116.828892] smpboot: CPU 2 is now offline [ 116.829180] intel_pstate CPU 3 exiting [ 116.830278] kvm: disabling virtualization on CPU3 [ 116.830288] smpboot: CPU 3 is now offline [ 116.831978] ACPI: Low-level resume complete [ 116.832042] PM: Restoring platform NVS memory [ 116.832448] Enabling non-boot CPUs ... [ 116.832496] x86: Booting SMP configuration: [ 116.832497] smpboot: Booting Node 0 Processor 1 APIC 0x2 [ 116.846706] kvm: enabling virtualization on CPU1 [ 116.875558] CPU1 is up [ 116.883372] smpboot: Booting Node 0 Processor 2 APIC 0x1 [ 116.895301] kvm: enabling virtualization on CPU2 [ 116.949650] CPU2 is up [ 116.949667] smpboot: Booting Node 0 Processor 3 APIC 0x3 [ 116.961905] kvm: enabling virtualization on CPU3 [ 116.969382] CPU3 is up [ 116.973196] ACPI: Waking up from system sleep state S3 [ 117.048104] xhci_hcd 0000:00:14.0: System wakeup disabled by ACPI [ 117.048860] pcieport 0000:06:03.0: quirk: wating for thunderbolt to reestablish pci tunnels... [ 117.048866] pcieport 0000:06:04.0: quirk: wating for thunderbolt to reestablish pci tunnels... [ 117.049028] pcieport 0000:06:05.0: quirk: wating for thunderbolt to reestablish pci tunnels... [ 117.049039] pcieport 0000:06:06.0: quirk: wating for thunderbolt to reestablish pci tunnels... [ 117.064086] thunderbolt 0000:07:00.0: resuming... [ 117.064087] thunderbolt 0000:07:00.0: control channel starting... [ 117.064088] thunderbolt 0000:07:00.0: starting TX ring 0 [ 117.064092] thunderbolt 0000:07:00.0: enabling interrupt at register 0x38200 bit 0 (0x0 -> 0x1) [ 117.064093] thunderbolt 0000:07:00.0: starting RX ring 0 [ 117.064097] thunderbolt 0000:07:00.0: enabling interrupt at register 0x38200 bit 12 (0x1 -> 0x1001) [ 117.064099] thunderbolt 0000:07:00.0: resetting switch at 0 [ 117.071730] thunderbolt 0000:07:00.0: 0: resuming switch [ 117.076029] thunderbolt 0000:07:00.0: resume finished [ 117.083894] PM: noirq resume of devices complete after 35.925 msecs [ 117.107976] PM: early resume of devices complete after 24.088 msecs [ 117.108077] mei_me 0000:00:16.0: irq 50 for MSI/MSI-X [ 117.108087] snd_hda_intel 0000:00:03.0: irq 51 for MSI/MSI-X [ 117.108178] snd_hda_intel 0000:00:1b.0: irq 52 for MSI/MSI-X [ 117.123854] sd 0:0:0:0: [sda] Starting disk [ 117.165153] thunderbolt 0000:07:00.0: resetting error on 0:b. [ 117.165167] thunderbolt 0000:07:00.0: resetting error on 0:c. [ 117.165174] thunderbolt 0000:07:00.0: 0:b: hotplug: scanning [ 117.165175] thunderbolt 0000:07:00.0: 0:b: hotplug: no switch found [ 117.165176] thunderbolt 0000:07:00.0: 0:c: hotplug: scanning [ 117.165177] thunderbolt 0000:07:00.0: 0:c: hotplug: no switch found [ 117.211747] pciehp 0000:06:00.0:pcie24: Device 0000:07:00.0 already exists at 0000:07:00, cannot hot-add [ 117.211748] pciehp 0000:06:00.0:pcie24: Cannot add device at 0000:07:00 [ 117.211765] rtc_cmos 00:02: System wakeup disabled by ACPI [ 117.223143] PM: resume of devices complete after 115.277 msecs [ 117.223294] PM: Finishing wakeup. [ 117.223295] Restarting tasks ... [ 117.223367] usb 2-3: USB disconnect, device number 2 [ 117.223655] [drm:hsw_unclaimed_reg_detect] *ERROR* Unclaimed register detected. Please use the i915.mmio_debug=1 to debug this problem. [ 117.225532] done. [ 117.225540] video LNXVIDEO:00: Restoring backlight state [ 117.227883] bcm5974: bad trackpad package, length: 8 [ 117.451554] ata1: SATA link up 6.0 Gbps (SStatus 133 SControl 300) [ 117.451786] ata1.00: unexpected _GTF length (8) [ 117.452052] ata1.00: unexpected _GTF length (8) [ 117.452084] ata1.00: configured for UDMA/133 [ 117.608944] asix 1-1:1.0 eth1: link down [ 117.609488] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready [ 119.026435] IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready [ 119.026983] asix 1-1:1.0 eth1: link up, 100Mbps, full-duplex, lpa 0xC1E1 -- You received this bug notification because you are a member of Kernel Packages, which is subscribed to linux in Ubuntu. https://bugs.launchpad.net/bugs/1371159 Title: [MacBookPro11,1] Unable to suspend in ubuntu 14.04 Status in linux package in Ubuntu: Incomplete Bug description: I cannot make a MacBookPro 11,1 suspend. When putting the lid down, acpi_listen prints: button/lid LID close button/lid LID open ... so the lid is signalling correctly. Upon opening, the screensaver prompt is present, and typing in the password brings me back to the desktop. Nothing is found in dmesg. When choosing "suspend" from the top-right power menu, the screen goes black and shortly lights up again, showing the screensaver login prompt. Typing in the password brings me back to the desktop as if nothing had happened. To remark that the power menu in the System Settings shows sometimes "Suspend" as greyed out. ProblemType: Bug DistroRelease: Ubuntu 14.04 Package: pm-utils 1.4.1-13ubuntu0.1 ProcVersionSignature: Ubuntu 3.13.0-35.62-generic 3.13.11.6 Uname: Linux 3.13.0-35-generic x86_64 NonfreeKernelModules: wl ApportVersion: 2.14.1-0ubuntu3.4 Architecture: amd64 CurrentDesktop: Unity Date: Thu Sep 18 10:36:54 2014 EcryptfsInUse: Yes InstallationDate: Installed on 2014-09-16 (2 days ago) InstallationMedia: Ubuntu 14.04.1 LTS "Trusty Tahr" - Release amd64 (20140722.2) PackageArchitecture: all SourcePackage: pm-utils UpgradeStatus: No upgrade log present (probably fresh install) --- ApportVersion: 2.14.1-0ubuntu3.6 Architecture: amd64 AudioDevicesInUse: USER PID ACCESS COMMAND /dev/snd/controlC1: albert 2149 F.... pulseaudio /dev/snd/controlC0: albert 2149 F.... pulseaudio CurrentDesktop: Unity DistroRelease: Ubuntu 14.04 EcryptfsInUse: Yes InstallationDate: Installed on 2014-09-16 (86 days ago) InstallationMedia: Ubuntu 14.04.1 LTS "Trusty Tahr" - Release amd64 (20140722.2) MachineType: Apple Inc. MacBookPro11,1 NonfreeKernelModules: wl Package: linux (not installed) ProcFB: 0 inteldrmfb ProcKernelCmdLine: BOOT_IMAGE=/boot/vmlinuz-3.13.0-43-generic root=UUID=1fe82ec9-9c83-4e33-9506-2f7afb8d9d64 ro libata.force=noncq quiet splash vt.handoff=7 ProcVersionSignature: Ubuntu 3.13.0-43.72-generic 3.13.11.11 RelatedPackageVersions: linux-restricted-modules-3.13.0-43-generic N/A linux-backports-modules-3.13.0-43-generic N/A linux-firmware 1.127.10 Tags: trusty Uname: Linux 3.13.0-43-generic x86_64 UpgradeStatus: No upgrade log present (probably fresh install) UserGroups: adm cdrom dip lpadmin plugdev sambashare sudo _MarkForUpload: True dmi.bios.date: 02/12/2014 dmi.bios.vendor: Apple Inc. dmi.bios.version: MBP111.88Z.0138.B07.1402121134 dmi.board.asset.tag: Base Board Asset Tag# dmi.board.name: Mac-189A3D4F975D5FFC dmi.board.vendor: Apple Inc. dmi.board.version: MacBookPro11,1 dmi.chassis.type: 10 dmi.chassis.vendor: Apple Inc. dmi.chassis.version: Mac-189A3D4F975D5FFC dmi.modalias: dmi:bvnAppleInc.:bvrMBP111.88Z.0138.B07.1402121134:bd02/12/2014:svnAppleInc.:pnMacBookPro11,1:pvr1.0:rvnAppleInc.:rnMac-189A3D4F975D5FFC:rvrMacBookPro11,1:cvnAppleInc.:ct10:cvrMac-189A3D4F975D5FFC: dmi.product.name: MacBookPro11,1 dmi.product.version: 1.0 dmi.sys.vendor: Apple Inc. To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1371159/+subscriptions -- Mailing list: https://launchpad.net/~kernel-packages Post to : kernel-packages@lists.launchpad.net Unsubscribe : https://launchpad.net/~kernel-packages More help : https://help.launchpad.net/ListHelp
