David: I tried what you suggested, and got the following results (which in one case seems to say that the newly generated version is used, and in the other that the old version is being used):
Try verifying by running these two commands: 1) "which fluidsynth", should return /usr/local/bin/fluidsynth aere@aere-Dell-DE051:~$ which fluidsynth /usr/local/bin/fluidsynth 2) "ldd /usr/local/bin/fluidsynth | grep fluid", should return "libfluidsynth.so.1 => /usr/local/lib/libfluidsynth.so.1" (followed by a hex number). aere@aere-Dell-DE051:~$ ldd /usr/local/bin/fluidsynth | grep fluid libfluidsynth.so.1 => /usr/lib/libfluidsynth.so.1 (0x00bb7000) So given these results, I still don't know which version of libfluidsynth1 is used. Keep in mind that I am using qsynth - not fluidsynth from the command line. For the purposes of the test, I could possibly run it from the command line, but I would have to figure out how to duplicate my qsynth configuration using command-line parameters, and the time in the past I tried that, it was not obvious how to do it. - Aere On Tue, 2012-07-31 at 22:50 +0200, David Henningsson wrote: > On 07/31/2012 10:39 PM, Aere Greenway wrote: > > David: > > > > I performed the steps for retrieving and building the release-candidate > > fluidsynth. > > Thanks! > > > Though it complained that DOXYGEN (or something like that) > > was not found, it seemed to build and install without any error. > > The doxygen error can be ignored. > > > I can supply printouts of the entire process, if that would be helpful. > > > > My testing also went well, since I did not discover any problems. > > > > The problem I have in doing this testing, is that I have no way of > > knowing if it used the libfluidsynth1 generated during the process, or > > what I was using before (the repackaged version of your PPA for Ubuntu > > 11.10). > > Try verifying by running these two commands: > > 1) "which fluidsynth", should return /usr/local/bin/fluidsynth > > 2) "ldd /usr/local/bin/fluidsynth | grep fluid", should return > "libfluidsynth.so.1 => /usr/local/lib/libfluidsynth.so.1" (followed by a > hex number). > > If the second one fails, i e, points to somewhere in "/usr/lib" instead > of the newly installed file in "/usr/local/lib", try running "sudo > ldconfig", then try again. > > Let me know how this goes. > > // David > -- Sincerely, Aere
_______________________________________________ fluid-dev mailing list fluid-dev@nongnu.org https://lists.nongnu.org/mailman/listinfo/fluid-dev
