It started working after I updated the grub.conf to have "enforcing=0". But entirely clear as to how it started working...any one can explain me?
On 3/12/07, Satish P <[EMAIL PROTECTED]> wrote: > When I built the kernel with that warning, > " > > $ make install > > sh /usr/src/linux-2.6.20.1/arch/i386/boot/install.sh 2.6.20.1 > > arch/i386/boot/bzImage System.map "/boot" > > WARNING: No module ata_piix found for kernel 2.6.20.1, continuing anyway > " > > I get the following when I boot it: > > " > Uncompressing Linux... Ok, booting the kernel. > Red Hat nash version 4.2.1.6 starting > Reading all physical volumes. This may take a while... > Found volume group .....................type lvm2 > 2 logical volumes ........................now active > Enforcing Mode requested but no policy loaded. Halting now. > Kernle panic - not syncing : Attempted to kill init! > " > Any suggestions are most welcome. > > Regards > Satish > > On 3/9/07, Satish P <[EMAIL PROTECTED]> wrote: > > When I perform 'make install', it gives me this Warning. I hope it is > > OK and I can continue. > > " > > $ make install > > sh /usr/src/linux-2.6.20.1/arch/i386/boot/install.sh 2.6.20.1 > > arch/i386/boot/bzImage System.map "/boot" > > WARNING: No module ata_piix found for kernel 2.6.20.1, continuing anyway > > " > > > > > > On 3/9/07, Satish P <[EMAIL PROTECTED]> wrote: > > > Basically I see "CONFIG_SCSI_ATA_PIIX=m" in my old config file > > > (/boot/config-2.6.9-22-EL) > > > And looks like I did not set that in my new config file > > > /usr/src/linux-2.6.20.1/.config > > > > > > I will set that and retry the kernel build. Hope I will get through my > > > previous panic! > > > > > > > > > > > > > > > On 3/9/07, Satish P <[EMAIL PROTECTED]> wrote: > > > > On 3/8/07, Horms <[EMAIL PROTECTED]> wrote: > > > > > On Wed, Mar 07, 2007 at 11:34:00PM -0500, Satish P wrote: > > > > > > > > > > > > That is very useful information. Thank you! > > > > > > If I understand correctly, you are saying that kexec feature now > > > > > > comes > > > > > > with 2.6.20.1 kernel. So, if I can download the sources for 2.6.20.1 > > > > > > onto my Linux box and build the kernel and load it, I should be all > > > > > > set? > > > > > > > > > > Yes. Well, for several architectures anyway. Which one are you using? > > > > > > > > For i386 arch. I have downloaded the sources and find the code in it. > > > > I have updated .config file to have CONFIG_KEXEC=y and followed the > > > > steps to buidl the kernel. > > > > But I have faced problem booting the new kernel. The initrd image did > > > > not see logical volumes and hence could not mount the root device and > > > > kernel got panic. > > > > Looks like I am missing on including some scsi module while > > > > configuring the new kernel. > > > > > > > > Regards > > > > Satish > > > > > > > > > > _______________________________________________ fastboot mailing list [email protected] https://lists.osdl.org/mailman/listinfo/fastboot
