Don, Thanks for the reply.
Unfortunately it reads 8.5 ohms. I'll have to look elsewhere. Kevin N8IQ -----Original Message----- From: Don Wilhelm [mailto:[EMAIL PROTECTED] Sent: Thursday, August 16, 2007 4:13 PM To: Kevin Shaw Cc: [email protected] Subject: Re: [Elecraft] PLL Clicks Kevin, Check RFC15 on the bottom of the RF Board. You must check it with an ohmmeter - even if it is open you will find 5 volts on both sides of it. Should you find it open and do not have an immediate replacement, short across it, replace the bottom cover and re-run CAL PLL - then check again for the clicks. 73, Don W3FPR Kevin Shaw wrote: > My K2 has the "PLL Click" problem when I turn the VFO. I've tried running > CAL PLL with the covers on, but no luck. > > > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
