Not hearing well could be the need for the filter alignments. Not sure
where you are in the process, there are voltage checks you can make in
the rear of the book, to help you understand where things should be.
Check your regulators, 8v and such to see they are running properly.
There is signal tracing information on N0SS or Don's site. With general
information, I can only give you general answers.
David Wilburn
[EMAIL PROTECTED]
K4DGW
K2 #5982
Gil Gibbs wrote:
I was going along fine on all my preliminary checks on my K2
"revival", got the sidetone going OK, then started in on the secondary
checks. To my dismay, I can't hear anything on any band, and I'm now
wondering if I let the smoke out of something in the receive. Not being
very good at tracing the schematic, I can't tell if the sidetone uses
the same circuit to the headphone plug that the receiver does or not.
Could I have fried a diode someplace, with that one problem of getting
the KIO2 wires "backward" when I wasn't paying attention, in the course
of setting up for the KAT100 addition?
This is beginning to get old - I'm using dummy load more often than
anything, and the SWL isn't a good result from all the hours. Any ideas,
out there?
Tnx, 73's
Gil WA5YKK
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
