I was going along fine on all my preliminary checks on my K2
"revival", got the sidetone going OK, then started in on the secondary
checks. To my dismay, I can't hear anything on any band, and I'm now
wondering if I let the smoke out of something in the receive. Not being
very good at tracing the schematic, I can't tell if the sidetone uses
the same circuit to the headphone plug that the receiver does or not.
Could I have fried a diode someplace, with that one problem of
getting the KIO2 wires "backward" when I wasn't paying attention, in the
course of setting up for the KAT100 addition?
This is beginning to get old - I'm using dummy load more often than
anything, and the SWL isn't a good result from all the hours. Any ideas,
out there?
Tnx, 73's
Gil WA5YKK
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
