On 7/17/07, Lee Buller <[EMAIL PROTECTED]> wrote:
Reading about K2 Power Cords...is there anyone out there making them that
look "commercially" made. I have made two sets of power cords (K2 and the
KAT100) and after I am done they look like "crap." They look bad. I guess it
is the way I am trying to put in fuses in the line and don't have a good way of
doing that.
I have a Powerpole connector based power bar that has the fuses in the
power bar, so I don't have to worry about that inline fuse connector
myself.
What I would suggest is using black (or red/black) lamp ('zip') cord,
and covering the inline fuse connector's wire leads with heat shrink
tubing. Also using a short amount of heat shrink tubing as strain
relief at the end connectors, rather than electrical tape.
Of course neatness is easier said then done.
-Michael, VE3TIX
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
