I have just installed a recently constructed KPA100 (including the latest upgrades) and appear to have run into the erratic power control problem.
Using Tune + Display and an external LP100 meter, if I request 5w I get 5w out. Increasing power to 11w so as to engage the pa I also get 11w out - so all seems fine. Switching to SSB, and speaking steadily into the mic, at a requested 5w I get approximately 5-7w out on each band. However increasing the power to 11w I get the following: 80m Req 11 Get 45 40m Req 11 Get 80 20m Req 11 Get 25 15m Req 11 Get 30 10m Req 11 Get 20 Reading back through the archive I see that others have encountered the same problem but cannot see a definitive answer to the problem. Anyone have any thoughts as to where to start looking. 73 to all Trevor G0KTN _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
