My K2-100 has an intermittent distortion on SSB whereby the signal appears
clean `on frequency` but has very bad splatter up and down the band `almost
like something arcing` to quote my local op who is monitoring it. LSB and
USB the same; CW clean. Have yet to determine if it is constant with KPA 100
in and out.
Distortion clears for no obvious reason and does not return despite abusing
power etc to try and instigate it.
My intial problem is that I have no efficient `in shack` way of monitoring
this and I need to resolve this.
I have checked and checked again the KSB2 board and all looks ok; have
searched through the reflector archives and notice someone may have had
similar and carried out a hard reset with some success ... anyone any ideas
please ?
Thank you
Terry
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
