Terry -
I had this problem. The cause was in the KPA100 T-R switch. Don W3FPR came up
with the solution. He increased C31 to 0.2 uf.
Don may chime in with better words of wisdom, but it's a place to start.
73 de K1ESE
John
[EMAIL PROTECTED] wrote:
My K2-100 has an intermittent distortion on SSB whereby the signal
appears clean `on frequency` but has very bad splatter up and down the
band `almost like something arcing` to quote my local op who is
monitoring it. LSB and USB the same; CW clean. Have yet to determine if
it is constant with KPA 100 in and out.
Distortion clears for no obvious reason and does not return despite
abusing power etc to try and instigate it.
My intial problem is that I have no efficient `in shack` way of
monitoring this and I need to resolve this.
I have checked and checked again the KSB2 board and all looks ok; have
searched through the reflector archives and notice someone may have had
similar and carried out a hard reset with some success ... anyone any
ideas please ?
Thank you
Terry
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
