This patch series include an attempt to avoid the use of custom
read and writes in driver code and use PCI subsystem common ones.
In order to do this map_bus callback is implemented and also a
data structure for driver is included. registers base address
is being readed from device tree and the driver gets clean a lot
of code.
I know some commits can be split better, but this series are sent
to get a feedback about if this is the correct way to clean this.
I cannot test this code also, only compile it, so it would be nice
to know if it runs and what should I check to complete it if not.
Thanks in advance for your time in reviewing this.
Best regards,
Sergio Paracuellos
Sergio Paracuellos (3):
staging: mt7621-pci: add data struct for mt7621 pci controller
staging: mt7621-pci: use generic kernel pci subsystem read and write
staging: mt7621-pci: remove dead code derived to not use custom reads
and writes
drivers/staging/mt7621-pci/pci-mt7621.c | 194 ++++++++++++--------------------
1 file changed, 72 insertions(+), 122 deletions(-)
--
2.7.4
_______________________________________________
devel mailing list
[email protected]
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
