Hello, Just another bump for the small doc patch and a reminder for another patch I sent, which still needs some smaller adaptations for lwIP ([PATCH] Basic lwIP for STM32H7 BSP) Kind Regards Robin Müller
On Thu, 21 Jan 2021 at 13:52, Robin Müller <robin.muelle...@gmail.com> wrote: > I'd just like to bump my patch. The last changes were just the formatting > changes from the code review. > > > Kind Regards > Robin > > On Tue, 12 Jan 2021 at 12:36, Robin Mueller <robin.muelle...@gmail.com> > wrote: > >> --- >> >> Added doc for board variation, added some fixes >> from code review. (typo and line width formatting) >> >> user/bsps/arm/stm32h7.rst | 18 +++++++++++++++++- >> 1 file changed, 17 insertions(+), 1 deletion(-) >> >> diff --git a/user/bsps/arm/stm32h7.rst b/user/bsps/arm/stm32h7.rst >> index 3eee511..e1b9d8c 100644 >> --- a/user/bsps/arm/stm32h7.rst >> +++ b/user/bsps/arm/stm32h7.rst >> @@ -11,16 +11,32 @@ This BSP supports the >> The BSP is known to run on these boards: >> >> * `STM32H743I-EVAL 2 < >> https://www.st.com/en/evaluation-tools/stm32h743i-eval.html>`_ >> +* `STM32H743ZI-Nucleo < >> https://www.st.com/en/evaluation-tools/nucleo-h743zi.html>`_ >> >> Clock Driver >> ------------ >> >> -The clock driver uses the `ARMv7-M Systick` module. >> +The clock driver uses the `ARMv7-M Systick` module. The HSE (external >> +oscillator) value can also be different for different evaluation or >> custom >> +boards, so it is recommended to check the default values of the BSP. >> >> Console Driver >> -------------- >> >> The console driver supports the on-chip UART and USART modules. >> +Different board variations use different GPIO pins and blocks for the >> default >> +communication UART and it is recommended to check whether the default >> +configuration provided is valid in the BSP. >> + >> +To specify that the BSP should be built for the STM32H743ZI-Nucleo board, >> +users can supply ``STM32H743ZI_NUCLEO == True`` to ``config.ini`` when >> +building the BSP. >> + >> +Alternatively, users can supply the configuration structs defined in >> ``hal.h`` >> +in the applicaton for other boards. For the console driver, the >> +``stm32h7_usartX_config`` structs are used to configure the GPIO pins >> and other >> +parameters. The default implementations can be found in >> +``bsps/arm/stm32ht/console`` in the RTEMS sources. >> >> Network Interface Driver >> ------------------------ >> -- >> 2.23.0.windows.1 >> >>
_______________________________________________ devel mailing list devel@rtems.org http://lists.rtems.org/mailman/listinfo/devel
