Maybe Kinsey has an idea. On Tue, Oct 6, 2020 at 1:29 AM small...@aliyun.com <small...@aliyun.com> wrote:
> The board is Ultra96 board with JTAG boot. > And yes, there is a bspsmp.c in rtems-5.1\bsps\arm\xilinx-zynqmp\start\ > > ------------------------------ > small...@aliyun.com > > > *From:* Gedare Bloom <ged...@rtems.org> > *Date:* 2020-10-06 00:16 > *To:* small...@aliyun.com > *CC:* devel <devel@rtems.org> > *Subject:* Re: I can not run rtems 5.1 smp correctly on bsp xilinx-zynqmp > It should, I believe. The bsp has bspsmp.c file. > > How did you configure (../rtems/configure)? > > What board/target do you run it on? > > On Mon, Oct 5, 2020 at 2:24 AM small...@aliyun.com <small...@aliyun.com> > wrote: > > > > Hi, all > > I compile rtems 5.1 with bsp xilinx-zynqmp. The single core mode is ok. > > But I can not use 2 or 3 or 4 cores of this bsp. > > After analysing the source code, I found there is no code to address smp > condition. Does rtems 5.1 indeed not support smp mode for xilinx-zynqmp bsp? > > > > ________________________________ > > small...@aliyun.com > > _______________________________________________ > > devel mailing list > > devel@rtems.org > > http://lists.rtems.org/mailman/listinfo/devel > > _______________________________________________ > devel mailing list > devel@rtems.org > http://lists.rtems.org/mailman/listinfo/devel
_______________________________________________ devel mailing list devel@rtems.org http://lists.rtems.org/mailman/listinfo/devel
