From: Pavel Pisa <p...@cmp.felk.cvut.cz> This support is required when newer firmware is used on Raspberry Pi 2 boards. --- c/src/lib/libbsp/arm/raspberrypi/Makefile.am | 3 +++ c/src/lib/libbsp/arm/raspberrypi/configure.ac | 4 ++++ 2 files changed, 7 insertions(+)
diff --git a/c/src/lib/libbsp/arm/raspberrypi/Makefile.am b/c/src/lib/libbsp/arm/raspberrypi/Makefile.am index abb6865..c9208d4 100644 --- a/c/src/lib/libbsp/arm/raspberrypi/Makefile.am +++ b/c/src/lib/libbsp/arm/raspberrypi/Makefile.am @@ -94,6 +94,9 @@ libbsp_a_SOURCES += ../../shared/sbrk.c libbsp_a_SOURCES += ../../shared/src/stackalloc.c libbsp_a_SOURCES += ../shared/startup/bsp-start-memcpy.S libbsp_a_SOURCES += ../shared/arm-cp15-set-ttb-entries.c +if BSP_START_IN_HYP_SUPPORT +libbsp_a_SOURCES += ../shared/startup/bsp-start-in-hyp-support.S +endif # Startup libbsp_a_SOURCES += ../../shared/bspreset_loop.c diff --git a/c/src/lib/libbsp/arm/raspberrypi/configure.ac b/c/src/lib/libbsp/arm/raspberrypi/configure.ac index 2676bef..ecaee3d 100644 --- a/c/src/lib/libbsp/arm/raspberrypi/configure.ac +++ b/c/src/lib/libbsp/arm/raspberrypi/configure.ac @@ -24,6 +24,10 @@ AM_CONDITIONAL(HAS_NETWORKING,test "$HAS_NETWORKING" = "yes") RTEMS_BSPOPTS_SET([BSP_START_RESET_VECTOR],[*],[]) RTEMS_BSPOPTS_HELP([BSP_START_RESET_VECTOR],[reset vector address for BSP start]) +RTEMS_BSPOPTS_SET([BSP_START_IN_HYP_SUPPORT],[*],[1]) +RTEMS_BSPOPTS_HELP([BSP_START_IN_HYP_SUPPORT], [Support start of BSP in ARM HYP mode]) +AM_CONDITIONAL(BSP_START_IN_HYP_SUPPORT,test "$BSP_START_IN_HYP_SUPPORT" = "1") + RTEMS_BSPOPTS_SET([I2C_IO_MODE],[*],[1]) RTEMS_BSPOPTS_HELP([I2C_IO_MODE],[Define to 1 to use interrupt-driven I/O with the Raspberry Pi I2C bus. If defined to other value the access will be polled-driven.]) -- 1.9.1 _______________________________________________ devel mailing list devel@rtems.org http://lists.rtems.org/mailman/listinfo/devel
