On Mon, May 10, 2004 at 10:19:55PM -0500, dircha wrote:
> > smeagol:~ 19:50:59 $ sudo ifup eth1
> > ifup: interface eth1 already configured
>
> , probably hotplug has attempted to configure your wireless card, and
> has done so incorrectly. Does the configuration displayed by the
> intervening "ifconfig" have the correct parameters for your wireless
> network?
Everything is right, except it's missing the line that normally says the
inet address.
eth1 IEEE 802.11-DS ESSID:"Wavelan Network" Nickname:"smeagol"
Mode:Managed Frequency:2.457GHz Access Point: 44:44:44:44:44:44
Bit Rate:2Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0/92 Signal level:134/153 Noise level:134/153
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
> But that's another issue. You should determine what is wrong with your
> (PCI?) ethernet card first, as that is more likely a much simpler issue.
I'm unsure of where to start looking. /var/log/syslog? dmesg? Should I be
looking for a card that fails to load, or something else?
thanks,
emma
--
Emma Jane Hogbin
[[ 416 417 2868 ][ www.xtrinsic.com ]]
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
