so sorry I sent the reply to the wrong address!it's my first time to use
maillist. i meant, for your laptop, perhaps you should use the up-to-date
kernel, 2.6.22.* version. it might contain the proper drivers for your
hardware.
在2007-08-31，"Marcelo Chiapparini" <[EMAIL PROTECTED]> 写道：
Hi! I need to install etch in a notebook which has MS-Vista installed. I have
shrinked the HD (using diskpart from inside Vista) in order to get room for
etch. I am using the etch netinstall cd, and the gui-expert mode with the
following parameters: "acpi=off pnpbios=off noapic noapm" (I need these
parameters in order to boot the Knoppix live CD, so, I guess the same are need
for etch). Everything is going fine until the stage where the HD is detected:
the etch installer doesn't detect any HD... The installed HD is a Western
Diginal Scorpio HD (WD800BEVS), using the SATA port 1. I wonder if I need any
special module to be loaded during the installation... Any help will be very
welcome. Regards Marcelo -- Marcelo Chiapparini [EMAIL PROTECTED] -- To
UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe".
Trouble? Contact [EMAIL PROTECTED]
