On Fri, 2007-08-31 at 12:04 -0300, Marcelo Chiapparini wrote: > Hi! > > I need to install etch in a notebook which has MS-Vista installed. I > have shrinked the HD (using diskpart from inside Vista) in order to get > room for etch. I am using the etch netinstall cd, and the gui-expert > mode with the following parameters: "acpi=off pnpbios=off noapic > noapm" (I need these parameters in order to boot the Knoppix live CD, > so, I guess the same are need for etch). Everything is going fine until > the stage where the HD is detected: the etch installer doesn't detect > any HD... > The installed HD is a Western Diginal Scorpio HD (WD800BEVS), using the > SATA port 1. I wonder if I need any special module to be loaded during > the installation... > Any help will be very welcome.
Hello! thanks to everyone who write helping. Finally, I used the lenny bussinescard cd, and the HD disk was recognized. Now, I am running lenny in the same machine with M$ Vista. Thanks again Marcelo -- Marcelo Chiapparini [EMAIL PROTECTED] -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
