Michael Pobega([EMAIL PROTECTED]) is reported to have said: > On Thu, Apr 12, 2007 at 07:14:35PM -0400, Wayne Topa wrote: > > Michael Pobega([EMAIL PROTECTED]) is reported to have said: > > > On Thu, Apr 12, 2007 at 04:40:39PM -0400, Wayne Topa wrote: > > > > Michael Pobega([EMAIL PROTECTED]) is reported to have said: > >
<--<snip>--> > > 1. Is 1UC68 the AP you want to connect to? > > 2. Is this an open AP? I have yet to add encryption to my AP so am > > not sure about this, but I can't find an 'key2' in the iwconfig man > > page. Also if its' open, whay the key?? > > > > 1. Yeah, 1UC68 is definitely the right ESSID. > 2. And yes, it is. I've configured my computer to connect to it so many > times it's one of those combinations that I'll remember when I'm forty > years old. > > > Anyway here is my working interfaces for a different card. > > > > auto eth1 > > iface eth1 inet dhcp > > pre-up modprobe ipw2100 > > pre-up ifconfig eth1 mtu 1492 > > post-down rmmod ipw2100 > > > > Again. This is for an open AP here. > > > > Should I pre-up modprobing? And what are you doing exactly with the > ifconfig command? I do that so I _won't_ automatically connect to an AP. I have 2 wifi cards and use them both with Kismet. Normally I am not looking to connect. If I want to I just have to do ifup eth1 and it will connect then. Sorry for the 2 posts, I was called away and wanted to get the answer out. My Bad. Wayne -- Failure is not an option, it comes bundled with the software. _______________________________________________________ -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
