|Wanting to replace my prehistoric 10base-T card with something that can |do 100, I bought myself a D-Link DFE-530TX and stuffed it into a free |PCI slot. So I Googled for drivers and I keep being told that the card |*is* supported, and uses the via-rhine drivers/module. But modprobe |via-rhine fails.
looks like the chip changed from 530tx (?) to 530 txs. try out the "sundance" module. (i know you have 530tx, but give it a try...) btw, with this card : sundance.c:v1.01b 17-Jan-2002 Written by Donald Becker http://www.scyld.com/network/sundance.html eth1: D-Link DFE-530TXS FAST Ethernet Adapter at 0xc28a0000, 00:05:5d:ff:2c:c4, IRQ 11. eth1: MII PHY found at address 0, status 0x7809 advertising 01e1. eth1: MII PHY found at address 1, status 0x7809 advertising 01e1. eth1: Link changed: 100Mbps, full duplex eth1: Setting full-duplex based on MII #0 negotiated capability 01e1. I've problems : NETDEV WATCHDOG: eth1: transmit timed out eth1: Transmit timed out, status 00, resetting... Rx ring c18da000: 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000 Tx ring c18db000: 80008001 80008005 80008009 8000800d 80008011 80008015 80018019 8001801d 80018021 80018025 80018029 8001802d 80018031 80008035 80008039 8000803d how should i debug this problem and how to spot a hardware error ? (vs a irq error, ....) thanks xavier renaut -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
