On Saturday 25 May 2002 02:07 pm, Rogerio Acquadro wrote: > On Fri, 24 May 2002, Kang-Ling Weng wrote: > > Hello debian-user, > > > > I have got 2 harddrives > > hda with Debian > > hdb with OpenBSD > > > > now I am trying to config lilo > > so that I am to boot into OpenBSD > > but when adding: > > > > other=/dev/hdb1 > > label=OpenBSD > > read-only > > alias=3 > > > > to lilo.conf > > and run: lilo > > the output looks like that: > > > > Skipping /vmlinuz.old > > Device 0x0340: Invalid partition table, 1st entry > > 3D address: 0/0/0 (-1) > > Linear address: 1/0/0 (0) > > > > it seems that lilo can't recognize hdb > > > > I tried: cfdisk hdb > > > > FATAL ERROR: Cannot open disk drive > > Press any key to exit cfdisk > > > > when I pull off the ide cable of my hda my pc boot > > into OpenBSD so OpenBSD was installed probably > > > > what should I modify in lilo.conf so I can boot into OpenBSD?? > > Is /dev/hdb1 BSD's /boot? I don't know much about *BSD, but I think that > there should exist /boot. Try to put /dev/hdb instead of /dev/hdb1.
additionally, you need to use /dev/hdb when using cfdisk. ben -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
