On Fri, 24 May 2002, Kang-Ling Weng wrote: > Hello debian-user, > > I have got 2 harddrives > hda with Debian > hdb with OpenBSD > > now I am trying to config lilo > so that I am to boot into OpenBSD > but when adding: > > other=/dev/hdb1 > label=OpenBSD > read-only > alias=3 > > to lilo.conf > and run: lilo > the output looks like that: > > Skipping /vmlinuz.old > Device 0x0340: Invalid partition table, 1st entry > 3D address: 0/0/0 (-1) > Linear address: 1/0/0 (0) > > it seems that lilo can't recognize hdb > > I tried: cfdisk hdb > > FATAL ERROR: Cannot open disk drive > Press any key to exit cfdisk > > when I pull off the ide cable of my hda my pc boot > into OpenBSD so OpenBSD was installed probably > > what should I modify in lilo.conf so I can boot into OpenBSD?? > Is /dev/hdb1 BSD's /boot? I don't know much about *BSD, but I think that there should exist /boot. Try to put /dev/hdb instead of /dev/hdb1.
-- ::: .''`. ::: Rogerio Acquadro <[EMAIL PROTECTED]> ::: : :' : ::: ICQ UIN: 6543753 ::: `. `'` ::: Administrador de rede - CCS - UNICAMP ::: `- ::: http://www.ccs.unicamp.br/~racquad -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
