Please CC me on all replies, since I'm not currently subscribed to the list.
I just got a netgear ma311 wireless network card and, after compiling a 2.4.20 kernel with the necessary hermes PCI/PCMCIA drivers (and just about every other wireless driver I could find, for that matter), I got my testing system to recognize it. However, I can't get it to actually do anything useful (I'm using my 3com wired card to post this). pump hangs whenever I run it with -i eth1 (where eth1 is the wireless card). Is pump the way to configure it? I wouldn't think it would be any different from configuring a wired network card (???).
>
(...)
Any ideas? Anything at all would probably be helpful.
Rather than using pump you should probably initially try with a fixed ip number. (ifconfig...)
I was recently setting up both an netgear access point and netgear pcmcia card with a siilar result. It turned out that I couldn't get an ip number through dhcp (pump) but had a fine connection with a fixed ip until I realized that a configuration change on the access point made a different: I had configured the access point with a fixed ip rather than using dhcp, so it chose not to forward the dhcp broadcast from the pcmcia card. WHen I made the access point use dhcp too (and configured the dhcp server to hand out a fixed ip number to the access point) dhcp finally worked for the pcmcia cards.
Andreas
-- Prof. Dr. Andreas J. Guelzow http://www.math.concordia.ab.ca/aguelzow
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
