On Sat, May 26, 2001 at 11:01:36AM -0700, Cam Ellison wrote: > I'm sure I'm missing something obvious here. > > I just installed an HP 9150i burner, and following the HOWTO plus some > information I picked up off this list (thanks to Osamu Aoki & Casey > Webster, plus several others), got it to work just fine. > > I have the burner as /hdc and another cdrom as /hdd. Both now show as > scsi devices (cdrecord -scanbus), but I cannot get anything to play on > the /hdd drive. > > I'm using xcdroast, and set it up originally to write to /hdc and read > from /hdd. It does both admirably. I have since set it to read and > write from /hdc only. > > When I start Gnome CDplayer, it starts scanning and then goes nowhere. > Attempts to play make it shut down. I cannot mount either /dev/hdd or > /dev/scd1 (which I assume should be the scsi equivalent, since the scsi > device number is 0,1,0). did you compile scsi cdrom support? scd0 is the first scsi cd drive, scd1 second....
look at your dmesg output, it will show lines like: Detected scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0 Detected scsi CD-ROM sr1 at scsi0, channel 0, id 1, lun 0 sr0: scsi3-mmc drive: 40x/40x xa/form2 cdda tray sr1: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray hope this helps... Alson -- ,-------------------------------------------. > Name: Alson van der Meulen < > Personal: [EMAIL PROTECTED] < > School: [EMAIL PROTECTED] < `-------------------------------------------' Ooops. Save your work, everyone. FAST! ---------------------------------------------
