See the many threads on this list about getting the Matrox G200 card working under Slink. I suspect that they apply to your problem also.
TNT is supported in 3.3.3.1. I don't know which server you should use though, I suspect that the SVGA server would be the one as that's usually where new card drivers get added these days. Matthew "Geocrawler.com" wrote: > > This message was sent from Geocrawler.com by "Joakim Svensson" <[EMAIL > PROTECTED]> > Be sure to reply to that address. > > Hi all, > > Sorry if this has been asked a million times before. Just don't read > on if it has. But if someone got a few minutes I would appreciate > it. > ..... > OK. Some problems. > > I have installed a "dialup" slink and it works well. But since I have > a tnt graphics card (ASUS V3400) I need xfree86 3.3.3.x ? > > So how should I proceed. > The 5 cd slink dist. has this 5th cd and it states it has > kde + new kernel + xfree 3.3.3. problem is I can't fint it > when I run dselect. I guess the best would be to solve this > problem using the cd-set so if anyone has any ideas how > I could do this it would be very good. > > Perhaps the cd's are wrong? How could I do then. Should I > configure ppp (without X) and use apt-get ? If this sounds > like a good idea I would really welcome some assistance. > > How do I set up my X without the 3.3.3 Xfree ? Can I run > it in vga mode or something ? (I tried this but couldn't get it > to work). > > So any ideas would be nice. I still think the best way is to get > the cd's to work properly. > > --- > is > xserver-comm3.3.3.1-x and > xserver-svga3.3.3.1-x the corrrect debs ? > > Best regards > Joakim Svensson > > > Geocrawler.com - The Knowledge Archive > > -- > Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null
