This message was sent from Geocrawler.com by "Joakim Svensson" <[EMAIL
PROTECTED]>
Be sure to reply to that address.
Hi all,
Sorry if this has been asked a million times before. Just don't read
on if it has. But if someone got a few minutes I would appreciate
it.
.....
OK. Some problems.
I have installed a "dialup" slink and it works well. But since I have
a tnt graphics card (ASUS V3400) I need xfree86 3.3.3.x ?
So how should I proceed.
The 5 cd slink dist. has this 5th cd and it states it has
kde + new kernel + xfree 3.3.3. problem is I can't fint it
when I run dselect. I guess the best would be to solve this
problem using the cd-set so if anyone has any ideas how
I could do this it would be very good.
Perhaps the cd's are wrong? How could I do then. Should I
configure ppp (without X) and use apt-get ? If this sounds
like a good idea I would really welcome some assistance.
How do I set up my X without the 3.3.3 Xfree ? Can I run
it in vga mode or something ? (I tried this but couldn't get it
to work).
So any ideas would be nice. I still think the best way is to get
the cd's to work properly.
---
is
xserver-comm3.3.3.1-x and
xserver-svga3.3.3.1-x the corrrect debs ?
Best regards
Joakim Svensson
Geocrawler.com - The Knowledge Archive
