I've gotten the IDE-SCSI emulation working in a 2.2 (2.2.9?)
kernel and have a lilo append line which allows the CDRW (a new Smart and
Friendly, JVC repackaged) to live on sg0 while the CD-ROM lives on hdd.
This works flawlessly. I've burned to this drive under linux (only a
couple of times) and ripped from the other. The CDRW is master on IDE1
and the CD-ROM is slave on IDE1.
I have CONFIG_BLK_DEV_IDESCSI=y, CONFIG_SCSI=y,
CONFIG_BLK_DEV_SD=y and CONFIG_CHR_DEV_SG=y as the chief differences
between my pre-CDRW kernel. My lilo.conf has :
image=/boot/vmlinuz-2.2.9
label=current
append="hdc=ide-scsi"
read-only
As the boot line.
I can send up the full .config, lilo.conf, dmesg, etc if you want.
ObNotAnExpert : When my kernel boots I get :
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
scsi : 1 host.
Vendor: SAF Model: CD-RW2224 Rev: 2.06
Type: CD-ROM ANSI SCSI revision: 02
Vendor: SAF Model: CD-RW2224 Rev: 2.06
Type: CD-ROM ANSI SCSI revision: 02
Vendor: SAF Model: CD-RW2224 Rev: 2.06
Type: CD-ROM ANSI SCSI revision: 02
Vendor: SAF Model: CD-RW2224 Rev: 2.06
Type: CD-ROM ANSI SCSI revision: 02
Vendor: SAF Model: CD-RW2224 Rev: 2.06
Type: CD-ROM ANSI SCSI revision: 02
Vendor: SAF Model: CD-RW2224 Rev: 2.06
Type: CD-ROM ANSI SCSI revision: 02
Vendor: SAF Model: CD-RW2224 Rev: 2.06
Type: CD-ROM ANSI SCSI revision: 02
Vendor: SAF Model: CD-RW2224 Rev: 2.06
Type: CD-ROM ANSI SCSI revision: 02
scsi : detected total.
As the kernel detection line. Why do I 8 detections of the drive?
In proc (I think) each of these instances is assigned a seperate LUN.
Anyone have a clue?
-Seth
--
"It is by will alone I set my mind in motion"
