i tried etherconf with no luck. my configuration boots with the 2.4.18bf2.4 kernel, but not my custom 2.4.18 kernel, and I assume the configurations should work with both if i have all the necessary kernel options enabled.
p. ----- Original Message ----- From: "Joyce, Matthew" <[EMAIL PROTECTED]> To: "'paul'" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Sent: Monday, October 07, 2002 9:37 PM Subject: RE: ifup, dhcp troubleshooting > You could try running etherconf to help construct a valid /etc/interfaces > > If it not already installed > apt-get install etherconf > > If is is already installed dpkg-reconfigure etherconf > > Matthew Joyce > > > > -----Original Message----- > From: paul [mailto:[EMAIL PROTECTED]] > Sent: Monday, 7 October 2002 12:38 PM > To: [EMAIL PROTECTED] > Subject: ifup, dhcp troubleshooting > > > Hello, I've recently compiled a fresh kernel (to get my audio working) and > have lost connectivity. I have a sis900 adapter built in to my board and I > configured the kernel to include the sis900 driver. The driver seems to be > working, ifconfig -a shows eth0, but I can't get an IP. If i try ifup eth0, > after a few seconds i get this: > > 'eth0: Media Link On 100mbps full-duplex' > > then it just sits there, so i ctl-c after a minute or two. Everything > worked before I compiled my own kernel, what components/options may I have > neglected in the kernel? > > Thanks in advance, > > Paul. > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact > [EMAIL PROTECTED] > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
