On Tue May 13 2008 12:51:37 am Jeffrey Ratcliffe wrote: > 2008/5/12 John Goerzen <[EMAIL PROTECTED]>: > > In the current release, every time I have 1 page selected and go to > > save, it defaults to All instead of Selected or Current. Almost > > always, I want to save only the selected page. gscan2pdf used to > > remember this, but no longer does. Could this be changed? > > I see this occasionally, but always when I have no time to > investigate, and later I can't reproduce it.
OK, this is on 0.9.23. I have a 6 pages in gscan2pdf. I clicked on page 3 on the left, so it is now selected (and highlighted in blue). I clicked on the floppy disk to save. All comes up. Changed it to Selected. Image type PNG. Saved it. Save box is still up. If I click cancel and save, then Selected is still selected. I click floppy disk again, this time saving as PDF with PNG compression. Selected is still highlighted. Type filename, it saves, and save box goes away. At this point, two different things could happen: 1) If I click on the floppy disk again immediately, it will still be selected. 2) If I click on page 4, then on the floppy disk, it will be back to All. Does that clarify enough for you? > > There were 2 bugs along these lines: #461859 and #465078: > > The logic is as follows (I've just tested it to make sure): > > If no pages is selected, default to All. > If 1 page is selected default to the most recent from All or Current. > If more than one page is selected, default to Selected. > > If you select more than one page, all open dialogs will change to > Selected, and on only selecting one, back to either All or Current, as > above. > > It isn't getting nailed by the delete bug any more - I've just checked. > > If you can describe how to reproduce this bug, I'll try and fix it. > > Regards > > Jeff -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
