hi Brian pin3 from serial is ok? on minicom you set option 115200 8N1 with no flow control?
2013/4/25 Brian Platt <[email protected]> > > Date: Mon, 15 Apr 2013 10:43:25 +0200 > > Subject: Re: Debian on thecus N2100 > From: [email protected] > To: [email protected] > CC: [email protected] > > > > > 2013/4/11 Brian Platt <[email protected]> > > > Date: Wed, 10 Apr 2013 22:20:18 +0400 > > From: [email protected] > > To: [email protected] > > Subject: Re: Debian on thecus N2100 > > > > > On 10.04.2013 16:41, Brian Platt wrote: > > > I'm tring to install debian on the Thecus N2100 using the instructions > from > > > http://www.cyrius.com/debian/iop/n2100/ however when formatting the > partitions the bar goes up to > > > 33% > > Try another hdd model. > > Tried that > > > maybe your RAM is damaged, try another one or to perform a memtest. > ciao > federico > > Finally got serial to work (ish) > > +RST=No > Transfer to factory test Mode : > No > Reset default > set:Normal > Thecus: Found PCI device Vendor > ID=0x0000FFFF > Thecus: Found PCI device Vendor > ID=0x000010EC > Thecus: Found PCI device Vendor > ID=0x0000FFFF > Thecus: Found PCI device Vendor > ID=0x0000FFFF > No network interfaces > found > > > RedBoot(tm) bootstrap and debug environment > [ROM] > Red Hat certified release, version 1.93 - built 17:25:00, Feb 6 > 2007 > > > Platform: THECUS N2100 > (IOP80219) > Copyright (C) 2000, 2001, 2002, Red Hat, > Inc. > > > RAM: 0x00000000-0x20000000, 0x0004b890-0x1ffd1000 available, total: 512 > MB > FLASH: 0xf0000000 - 0xf1000000, 128 blocks of 0x00020000 bytes > each. > == Executing boot script in 3.000 seconds - enter ^C to abort > > I would like to boot into redboot but when I do control c it' doesn't > abort the boot? >
