Patrick,
Come to think of it, you are correct. I had to cut a bigger hole
for the Airmar speed transducer, and not the depth transducer, as I previously
and erroneously stated.
My bad.
Steve Thomas
C&C27 MKIII
C&C36 MKI
----- Original Message -----
From: Patrick Davin via CnC-List
To: [email protected]
Cc: Patrick Davin
Sent: Wednesday, November 25, 2015 10:19
Subject: Re: Stus-List Removal of Datamarine depth transponder
<snip>
@ Steve Thomas: The Datamarine speed transducer in my experience was exactly
the same diameter as the Airmar transducers. Are you saying the depth trans is
smaller than the speed? That would be surprising, but I suppose it's possible.
-Patrick
C&C LF38
------------------------------------------------------------------------------
_______________________________________________
Email address:
[email protected]
To change your list preferences, including unsubscribing -- go to the bottom
of page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
Email address:
[email protected]
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
