Hi Dmitri and Tony, thank you both very much for your answers. I'm on my way to rip out a switch from an old computer case so I can start the master node for the first time (hopefully without calling the firemen and an ambulance :) ).
I'll setup the BIOS as you've told me: "ON after AC loss". Does that mean that next time it will be turned on(off) when the PS is turned on(off)? I know I only have 2 nodes and I can use the switches, but if this works, I'll be expanding it, so I want this problem covered (12 on/off switches... I'm too lazy for that). :) If I do this, I can power the master with PS on switch, and use the switch I have for adding another node with the same setup: set it up to run diskless, set it's BIOS the same way, turn it off, disconnect the switch and use it for adding another node. Is this OK? Best regards, Tomislav _______________________________________________ Beowulf mailing list, Beowulf@beowulf.org sponsored by Penguin Computing To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
