Tomislav Maric wrote:
Hi again,
where can I get an "on/off" and "reset" switch for ATX motherboard
without buying and ripping apart a case?
Should I make one? I'm planning on having up to 12 mobos: should I use
software for powering them off and reseting them (i.e. over LAN), or
make a bunch of switches and place them in a case? Any suggestions?
I'm afraid to use a screwdriver and short circuit the pins. :)
Hello, Tomislav.
You could set the BIOS to power state to "ON after AC loss".
I do this because I have lots of COTS PC's in tower cases on industrial
shelving in our computer room and it's awkward to go round pressing all
the on/off switches ;-)
Bye,
Tony.
--
Dr. A.J.Travis, University of Aberdeen, Rowett Institute of Nutrition
and Health, Greenburn Road, Bucksburn, Aberdeen AB21 9SB, Scotland, UK
tel +44(0)1224 712751, fax +44(0)1224 716687, http://www.rowett.ac.uk
mailto:a.tra...@abdn.ac.uk, http://bioinformatics.rri.sari.ac.uk/~ajt
_______________________________________________
Beowulf mailing list, Beowulf@beowulf.org sponsored by Penguin Computing
To change your subscription (digest mode or unsubscribe) visit
http://www.beowulf.org/mailman/listinfo/beowulf
