Small update:
If we load cape-universala and run the following command in terminal the PRU seems to be able to toggle the pins in question: config-pin P9_31 pruout This is only a temporary solution until a final solution for the device tree can be found, It should be possible to use the overlay to configure the GPIO pinmux correctly no? Based on this I think we can conclude there is still some issue with the device tree overlay settings. But we have no clue what it would be at this point. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/013235ba-3449-4568-be77-ca7379637765%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
