I switched to a arduino Uno and problem persisted. Then discovered I had read the data sheet wrong. The schematic of the pins is looking from the bottom up while I had connected as if the schematic was looking at the top downwards. Once I connected it correctly, it worked on arduino, raspberry pi and beaglebone. I hope that makes sense and I'm not the only one to read it wrong 😊
-- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/92854e47-36a3-458b-904d-4d727690e753%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
