Thank you again! On Tuesday, November 8, 2016 at 1:25:21 AM UTC+2, William Hermans wrote: > > > > On Mon, Nov 7, 2016 at 3:56 PM, Theodosis Ntegiannakis < > [email protected] <javascript:>> wrote: > >> I tried twice to implement my own overlay but I gave up because I had a >> significant lack of knowledge at this point. >> >> Finally i used cape-universala (in which pwm works fine) and enabled >> uart2 and uart4 pins by using config-pin. >> Now it works! (hope nothing else has broken!) >> >> Thank you very much! >> >> >> one last question: >> pins enabled using config-pin command are enabled until reboot. >> >> how can i keep these pins after reboot? >> >> >> You create a systemd service, or use rc.local, and put the "commands" in > there. Which will be applied at boot. > >
-- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/e44164d9-1708-49b1-a2dc-e239b43ff20f%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
