On Mon, Nov 7, 2016 at 3:56 PM, Theodosis Ntegiannakis < [email protected]> wrote:
> I tried twice to implement my own overlay but I gave up because I had a > significant lack of knowledge at this point. > > Finally i used cape-universala (in which pwm works fine) and enabled uart2 > and uart4 pins by using config-pin. > Now it works! (hope nothing else has broken!) > > Thank you very much! > > > one last question: > pins enabled using config-pin command are enabled until reboot. > > how can i keep these pins after reboot? > > > You create a systemd service, or use rc.local, and put the "commands" in there. Which will be applied at boot. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CALHSORpEHkkqXBmm%2BEUWn_qcGbogOc3MFpTyH9ksWeaUOrSy_w%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
