Hi Jason, After you asked the OpenROV project on Github on what to do to get OpenROV over to debian I had a go at the Debian images.
I tried to get the latest Debian demo image (from http://elinux.org/BeagleBoardDebian) running on the BeagleBone Black (I think its a revision B). I tested it with both, debian-7.5-console-armhf-2014-05-06.tar.xz and debian-jessie-console-armhf-2014-05-06.tar.xz and wrote it to an SD card with --dtb beaglebone. But when I put it in the BBB it doesn't seem to boot up properly. I can't get a network connection, not on the LAN port nor if I connect it via USB to my laptop. I checked the /var/log/messages and /var/log/dmesg afterwards and it ends with a message that the root partition wasn't cleanly unmounted and should be checked with fsck but nothing more. The heartbeat is still going on though. I will try to hook up a second BBB via UART to the serial debug output to see if I can get anything more. Do you have any hint in what could cause that issue? Beside that, I will test the demo image from http://beagleboard.org/latest-images/ too. Regards, Dominik On Wed, May 21, 2014 at 11:41 AM, Jason Kridner <[email protected]> wrote: > http://beagleboard.org/latest-images/ now has the 2014-05-14 image linked > and CircuitCo is making the switch to flashing this on the board thanks to > improvements in the flasher. Primarily, the flasher now shuts the board > down after boot, so the LEDs will be all off, rather than all on when the > flash completes. Note that the next revision will likely also change the > LED flashing patterned during the flashing operation. > > See notes at > http://elinux.org/Beagleboard:BeagleBoneBlack_Debian#2014-05-14 and reply > to the list if you have any issues/questions/doubts/etc... > > I also made a small blog post at > http://beagleboard.org/blog/2014-05-21-beaglebone-black-image-update. > > (and don't forget the bug report site: > http://bugs.elinux.org/projects/debian-image-releases) > > -- > You received this message because you are subscribed to the Google Groups > "Beagle Alpha" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- Twitter: @codewithpassion Blog: http://www.codewithpassion.com -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
