Thanks! I'll spend some time with this information, check the pinouts and I should be well on my way. Glad to know it can work! ;-)
-Darren -- Darren Nickerson Senior Sales & Support Engineer iFAX Solutions, Inc. www.ifax.com [EMAIL PROTECTED] +1.215.438.4638 ext 8106 office +1.215.243.8335 fax ----- Original Message ----- From: "Darren Nickerson" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, April 16, 2004 1:29 AM Subject: [Asterisk-Users] TE405P + Adit 600 and FXO module - should this work? > Folks, > > I'm experimenting with bringing multiple (8) analog lines from our local > telco into a Carrier Access ADIT 600 channel bank with an FXO module, then > having this talk to Asterisk via the T1 TDM controller on the ADIT and a > TE405P card. > > I don't know if this will work well (ie: give me decent echo cancellation, > call disconnect supervision, caller ID etc) but I haven't had much luck > getting this combination flying at all thus far. Should it work? > > I've been concentrating on the Adit T1 interface <----> TE405P connection > ... and have the following in zapata.conf: > > span=1,1,0,esf,b8zs > fxsks=1-24 > loadzone = us > defaultzone=us > > At the end of my zaptel.conf, I have: > > signalling=fxs_ks > group=2 > callerid="Joe Schmoe" <(215) 555-1212> > channel => 1-24 > > To get things flying, I do: > > modprobe zaptel > modprobe wct4xxp > > which causes the TE405P card to activate, but show a single flashing red > alarm on the configured span. > > The Adit's TDM controller also displays a solid red LED. Here's its status: > > Adit 600> status a:1 > SLOT A: > Status for DS1 1: > Receive: Loss of Signal > Transmit: RAI/Yellow Alarm > Loopback: OFF > > Adit 600> > > I'm not sure I have the DS1 configured appropriately. It says: > > Adit 600> show a:1 > SLOT A: > Settings for DS1 1: > Circuit ID: CAC DS1# A:1 > Up/Down: UP > Framing: ESF > Line Coding: B8ZS > Line Build Out: DSX-1 EQUALIZATION FOR 0-133 ft. (CSU 0dB) > Loop Code Detection: ON > Loopback: OFF > FDL Type: None > > Can anyone familiar with the Adit 600 and/or TE405P see any obvious errors > here? > > -Darren > > -- > Darren Nickerson > Senior Sales & Support Engineer > iFAX Solutions, Inc. www.ifax.com > [EMAIL PROTECTED] > +1.215.438.4638 ext 8106 office > +1.215.243.8335 fax > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
