- check this link for info on Adit-600 configuration http://lists.digium.com/pipermail/asterisk-users/2003-June/013072.html
-Make sure the pinouts for your T1 cable are correct:
DigiumT1 -> RJ-48(F) X-over
Digium T1 Card Channel Bank RJ-48(F)
Pin Pair# T/R Color Pin T/R
1 2 T white/orange 4 R1
2 2 R orange/white 5 T
4 1 T blue/white 1 R
5 1 R white/blue 2 T1
3, 6, 7, 8 Not assigned
Darren Nickerson wrote:
Folks,
I'm experimenting with bringing multiple (8) analog lines from our local telco into a Carrier Access ADIT 600 channel bank with an FXO module, then having this talk to Asterisk via the T1 TDM controller on the ADIT and a TE405P card.
I don't know if this will work well (ie: give me decent echo cancellation, call disconnect supervision, caller ID etc) but I haven't had much luck getting this combination flying at all thus far. Should it work?
I've been concentrating on the Adit T1 interface <----> TE405P connection ... and have the following in zapata.conf:
span=1,1,0,esf,b8zs fxsks=1-24 loadzone = us defaultzone=us
At the end of my zaptel.conf, I have:
signalling=fxs_ks group=2 callerid="Joe Schmoe" <(215) 555-1212> channel => 1-24
To get things flying, I do:
modprobe zaptel modprobe wct4xxp
which causes the TE405P card to activate, but show a single flashing red alarm on the configured span.
The Adit's TDM controller also displays a solid red LED. Here's its status:
Adit 600> status a:1 SLOT A: Status for DS1 1: Receive: Loss of Signal Transmit: RAI/Yellow Alarm Loopback: OFF
Adit 600>
I'm not sure I have the DS1 configured appropriately. It says:
Adit 600> show a:1 SLOT A: Settings for DS1 1: Circuit ID: CAC DS1# A:1 Up/Down: UP Framing: ESF Line Coding: B8ZS Line Build Out: DSX-1 EQUALIZATION FOR 0-133 ft. (CSU 0dB) Loop Code Detection: ON Loopback: OFF FDL Type: None
Can anyone familiar with the Adit 600 and/or TE405P see any obvious errors here?
-Darren
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
