Mike Machado wrote:
cvs HEAD did infact fix the ringing problem. Thanks Eric!
I have another question for all you T1 buffs out there. The T1 I am
working with goes into our local phone switch (Excel switch). Currently
we are using E & M Wink signaling. The problem is we cannot set callerid
on the outbound side. My minimal understanding is that if we had a PRI,
I could set the callerID. Unfortunately PRI is one signaling type they
cannot do (not have expensive PRI card in switch).
So, my question is what other signaling types CAN I set the callerID
outbound?
My local switch techs cannot seem to answer that question. They just
always use E & M for everything. But if I can ask them to specifically
try a certain signaling type (such as Feature Group D) or one of the
others in the t100p supported list, I could probably get them to change
the signaling type on my trunk. Do any signaling types other than PRI
support passing outbound callerID?
You can usually get CLI on an E&M robbed bit T1 by configuring it right.
Instead of just sending you the DNIS as a string of DTMF they usually
send *<cli>*<dnis>*. The DNIS and CLI may be swapped, and there may be
less than 3 *s in the string - wonderful consistency, eh? :-\
Regards,
Steve
_______________________________________________
Asterisk-Users mailing list
[EMAIL PROTECTED]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
