On 6/4/06, Andrew D Kirch <[EMAIL PROTECTED]> wrote:
I am currently running Asterisk 1.2.8, on an AMD Sempron 3100+ (ASUS K8N
Nforce based board). I am using a Digium wctdm24xxp to terminate 8 (2x
quad) FXO lines. Using ztmonitor (From zapata) I cannot see that there is
any registerable incoming volume from these lines. I've been running them
at rxgain = 25 (zapata.conf) to make the audio audible, however this
creates poor call quality issues (static and distortion) on most calls,
and audio garble in voicemails. Fxotune fails for every line with "Could
not fill input buffer"
I've tried changing PCI slots, played with echo settings, and done
everything else I can think of to make this card play nice to no avial.
Anyone with solutions or ideas, your input will be greatfully appreciated.
Hi,
I'm using one of these cards with 3 quad modules (4 x FXO, 8 x FXS)
and I didn't have to touch the rxgain/txgain (0.0 for both). This is
how it should be set. If you need to adjust these settings, then you
have another problem. I know you tried changing PCI slots, but have
you looked at /proc/interrupts to see if the card is sharing an IRQ
with another device?
Regards,
Gonzalo.
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
