I just tested an ATA-186 to verify what I had said in the negative, and I find that leaving the ConnectMode set to 0x00060400 (the default from the factory on v2.15) doesn't seem to make a difference - my ATA behind a NAT worked just fine. Go figure.
JT
You may have read the earlier posts on it, but to make sure: you did set ConnectMode to 0x00460400 right? Also, you have "nat=1" in the settings for your ATA-186 in sip.conf? Both are required for correct functionality as far as I've seen.
(Note: I've got an ATA-186 on a public IP address connected to * now with ConnectMode set to 0x00460400 with seemingly no adverse issues. Can anyone else verify? This would be convenient for general configuration for bulk roll-outs if both public and private addressed ATA-186's can have the same settings.)
JT
At 4:17 PM -0600 3/11/03, Matthew Farley wrote:
After sending my most recent message, I realized that I did not word it clearly. In case of any confusion as to my configuration, my Asterisk machine has a public IP, and the ATA186 is behind a NAT firewall. My apologies for any confusion.
-- Matthew Farley <[EMAIL PROTECTED]>
On your Cisco ATA-186:
Set your IP address information as usual (use DHCP, or static, whatever your site requires)
UID0: [your UID]
PWD0: [this UID's password]
UseSIP: 1
SIPRegInterval: 240
GkOrProxy: [ip address of your Asterisk server]
Gateway: [ip address of your Asterisk server]
ConnectMode: 0x00460400
OutBoundProxy: [ip address of your Asterisk server]
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
