Re: [Asterisk-Users] Clarification (SIP Behind NAT question)

[John Todd]

You may have read the earlier posts on it, but to make sure: you did 
set ConnectMode to 0x00460400 right?  Also, you have "nat=1" in the 
settings for your ATA-186 in sip.conf?  Both are required for correct 
functionality as far as I've seen.

(Note: I've got an ATA-186 on a public IP address connected to * now 
with ConnectMode set to 0x00460400 with seemingly no adverse issues. 
Can anyone else verify?  This would be convenient for general 
configuration for bulk roll-outs if both public and private addressed 
ATA-186's can have the same settings.)

JT

At 4:17 PM -0600 3/11/03, Matthew Farley wrote:
After sending my most recent message, I realized that I did not word it
clearly. In case of any confusion as to my configuration, my Asterisk
machine has a public IP, and the ATA186 is behind a NAT firewall. My
apologies for any confusion.
--
Matthew Farley <[EMAIL PROTECTED]>



On your Cisco ATA-186:

Set your IP address information as usual (use DHCP, or static, 
whatever your site requires)
UID0: [your UID]
PWD0: [this UID's password]
UseSIP: 1
SIPRegInterval: 240
GkOrProxy: [ip address of your Asterisk server]
Gateway: [ip address of your Asterisk server]
ConnectMode: 0x00460400
OutBoundProxy: [ip address of your Asterisk server]


_______________________________________________
Asterisk-Users mailing list
[EMAIL PROTECTED]
http://lists.digium.com/mailman/listinfo/asterisk-users