Try the 13.2 firmware? Spectrum scan looking good? — Sent from Mailbox
On Tue, Oct 21, 2014 at 12:44 PM, Craig House via Af <[email protected]> wrote: > No they were 230s on there before and I did try to re-aim them both up and > down and side to side signal was a -59 in backhaul master evalbut it kept > saying BER rate and told it to rescan > Sent from my iPhone >> On Oct 21, 2014, at 11:43, timothy steele via Af <[email protected]> wrote: >> >> Dishes has 100 replaced with 450 and no re aim? Point dish up a few degrees >> on each end >> >> — >> Sent from Mailbox >> >> >>> On Tue, Oct 21, 2014 at 12:22 PM, Craig House via Af <[email protected]> wrote: >>> We have put up our first pair of backhaul 450 radios today 5.5 mile wink >>> signal before was a -51 on both ends dishes did not get repointed just >>> replace the radios >>> The radio see each other at a -59 signal but they will not connect up says >>> that the BER is too high >>> This is from a water tower to a 600 foot communications tower that is easy >>> line of sight from 40 feet lower on each end >>> Is there a special trick to making these radios connect? >>> >>> Sent from my iPhone >>> >>
