We have seen some weirdness with them in the office and have not
deployed them. Difficulty in getting them to connect. My other issue
is the very low limit on downlink % - something like 55 if you run them
in the 5.4 band. This makes it not much better in throughput than a 230
backhaul (which also has odd signal issues on recent firmware) unless
you can get 8/8 modulation.
Hey Mimosa - send me some backhauls...
Mark
On 10/21/14, 12:44 PM, Craig House via Af wrote:
As a sidenote I have also tried to get them to connect on different
channels and in a 10 MHz channel it still did not work
Sent from my iPhone
On Oct 21, 2014, at 11:43, timothy steele via Af <[email protected]
<mailto:[email protected]>> wrote:
Dishes has 100 replaced with 450 and no re aim? Point dish up a few
degrees on each end
—
Sent from Mailbox <https://www.dropbox.com/mailbox>
On Tue, Oct 21, 2014 at 12:22 PM, Craig House via Af <[email protected]
<mailto:[email protected]>> wrote:
We have put up our first pair of backhaul 450 radios today 5.5
mile wink signal before was a -51 on both ends dishes did not get
repointed just replace the radios
The radio see each other at a -59 signal but they will not
connect up says that the BER is too high
This is from a water tower to a 600 foot communications tower
that is easy line of sight from 40 feet lower on each end
Is there a special trick to making these radios connect?
Sent from my iPhone
--
Mark Radabaugh
Amplex
[email protected] 419.837.5015 x 1021
