Timothy S. Nelson escribió:
Hi all. I'm upgrading from Fedora 6 to Fedora 10. I did a clean
install of Fedora 10 and then, as the default X config didn't work, I
copied across my old xorg.conf file. Naturally I had to comment out a
few lines in that file.
Now a word on my setup. I have two screens, one hanging off an
nVidia card, and the other on a SiS card. Both of them work just fine
under Fedora 6.
Anyway, after I did the steps above, I found it didn't work, so
I've been trying one screen at a time. The SiS one works (unless I
install the proprietary nVidia driver, so I removed that). The nVidia
one doesn't work. I've tried the nv driver, the fbdev driver, and the
vesa driver, all of which failed, although not always with the same
error message. As nv is the one that worked with Fedora 6, that's the
way I'd prefer to go (because it should be possible), but I'm open to
other solutions.
When I try to use the nv driver, the console appears to be hung,
but it's still possible to ssh into the machine. The last entry in the
log read as follows:
I have a similar problem on my setup, but I am not trying to set up a
multihead configuration. Rather, I wanted to start up a secondary video
card in order to write a proper driver for it.
My primary chipset is a ProSavageDDR-K (handled by savage_drv.so) at
PCI:1:0:0. As an exercise, I want to write a driver for an Oak Spitfire
OTI64111 PCI video card, which is plugged on the same machine that has
the savage chipset. The oti64111 card (at PCI:0:9:0) can be handled
correctly with the vesa driver, and I have been using it to set up the
card so I can peek into the graphics registers. In Fedora 8, I used the
configuration file attached to this message in order to initialize the
oti64111. This had the effect of blanking the screen attached to the
savage chipset, and then booting the oak64111 BIOS and showing the
familiar X cursor with the patterned background. Although a little
problematic, I could switch back and forth between the two running X
servers.
Under Fedora 10, an attempt to use the same method results in a hung
machine. Now I have to reboot and select the BIOS option "Primary
graphics card: (PCI/AGP)" and select AGP for the savage chipset (the
normal setting) or PCI for the oak64111. Maybe this is of some help in
solving the problem.
--
perl -e '$x=2.4;print sprintf("%.0f + %.0f = %.0f\n",$x,$x,$x+$x);'
# Xorg configuration created by livna-config-display
Section "ServerLayout"
Identifier "Default Layout"
Screen 0 "Screen1" 0 0
EndSection
Section "ServerFlags"
Option "AIGLX" "on"
EndSection
Section "Monitor"
Identifier "SyncMaster"
VendorName "Monitor Vendor"
ModelName "SyncMaster"
DisplaySize 280 210
HorizSync 30.0 - 57.99
VertRefresh 50.0 - 120.0
ModeLine "720x540" 39.2 720 752 824 928 540 541 544 564 -hsync
+vsync
# 1152x864 @ 64.60 Hz (GTF) hsync: 57.95 kHz; pclk: 89.01 MHz
Modeline "1152x864" 89.01 1152 1224 1344 1536 864 865 868 897 -HSync
+Vsync
# 1200x900 @ 62.10 Hz (GTF) hsync: 57.94 kHz; pclk: 92.70 MHz
Modeline "1200x900" 92.70 1200 1272 1400 1600 900 901 904 933 -HSync
+Vsync
# 1216x912 @ 61.20 Hz (GTF) hsync: 57.83 kHz; pclk: 93.46 MHz
Modeline "1216x912" 93.46 1216 1288 1416 1616 912 913 916 945 -HSync
+Vsync
# 1280x960 @ 58.37 Hz (GTF) hsync: 57.96 kHz; pclk: 98.30 MHz
Modeline "1280x960" 98.30 1280 1352 1488 1696 960 961 964 993 -HSync
+Vsync
# 1360x960 @ 58.31 Hz (GTF) hsync: 57.90 kHz; pclk: 104.69 MHz
Modeline "1360x960" 104.69 1360 1440 1584 1808 960 961 964 993 -HSync
+Vsync
# 1360x1020 @ 55.07 Hz (GTF) hsync: 57.99 kHz; pclk: 104.84 MHz
Modeline "1360x1020" 104.84 1360 1440 1584 1808 1020 1021 1024 1053
-HSync +Vsync
EndSection
Section "Device"
Identifier "Videocard1"
Driver "vesa"
BusID "PCI:0:9:0"
Option "ModeDebug" "on"
EndSection
Section "Screen"
Identifier "Screen1"
Device "Videocard1"
Monitor "SyncMaster"
DefaultDepth 16
SubSection "Display"
Depth 15
Modes "800x600" "640x480"
EndSubSection
SubSection "Display"
Depth 16
Modes "800x600" "640x480"
# "1280x960" "1152x864" "1024x768" "800x600" "640x480"
EndSubSection
SubSection "Display"
Depth 24
Modes "800x600" "640x480"
EndSubSection
EndSection
Section "Extensions"
Option "Composite" "Enable"
EndSection
X.Org X Server 1.5.3
Release Date: 5 November 2008
X Protocol Version 11, Revision 0
Build Operating System: Linux 2.6.18-92.1.10.el5 i686
Current Operating System: Linux karlalex.palosanto.com 2.6.27.5-117.fc10.i686 #1 SMP Tue Nov 18 12:19:59 EST 2008 i686
Build Date: 16 November 2008 08:29:02PM
Build ID: xorg-x11-server 1.5.3-5.fc10
Before reporting problems, check http://wiki.x.org
to make sure that you have the latest version.
Markers: (--) probed, (**) from config file, (==) default setting,
(++) from command line, (!!) notice, (II) informational,
(WW) warning, (EE) error, (NI) not implemented, (??) unknown.
(==) Log file: "/var/log/Xorg.1.0.log", Time: Tue Dec 2 00:25:44 2008
(++) Using config file: "/etc/X11/xorg-test.conf"
(==) ServerLayout "Default Layout"
(**) |-->Screen "Screen1" (0)
(**) | |-->Monitor "SyncMaster"
(**) | |-->Device "Videocard1"
(**) Option "AIGLX" "on"
(==) Automatically adding devices
(==) Automatically enabling devices
(==) No FontPath specified. Using compiled-in default.
(==) FontPath set to:
catalogue:/etc/X11/fontpath.d,
built-ins
(==) ModulePath set to "/usr/lib/xorg/modules"
(**) Extension "Composite" is enabled
(II) Cannot locate a core pointer device.
(II) Cannot locate a core keyboard device.
(II) The server relies on HAL to provide the list of input devices.
If no devices become available, reconfigure HAL or disable AllowEmptyInput.
(II) Open ACPI successful (/var/run/acpid.socket)
(II) Loader magic: 0x81f4400
(II) Module ABI versions:
X.Org ANSI C Emulation: 0.4
X.Org Video Driver: 4.1
X.Org XInput driver : 2.1
X.Org Server Extension : 1.1
X.Org Font Renderer : 0.6
(II) Loader running on linux
(--) using VT number 7
(--) PCI: ([EMAIL PROTECTED]:9:0) Oak Technology, Inc OTI-64111 [Spitfire] rev 16, Mem @ 0xdffff000/0, 0xdf000000/0, I/O @ 0x0000ec00/0, BIOS @ 0x????????/32768
(--) PCI:*([EMAIL PROTECTED]:0:0) S3 Inc. VT8375 [ProSavage8 KM266/KL266] rev 0, Mem @ 0xdee80000/0, 0xd0000000/0, BIOS @ 0x????????/65536
(II) System resource ranges:
[0] -1 0 0xffffffff - 0xffffffff (0x1) MX[B]
[1] -1 0 0x000f0000 - 0x000fffff (0x10000) MX[B]
[2] -1 0 0x000c0000 - 0x000effff (0x30000) MX[B]
[3] -1 0 0x00000000 - 0x0009ffff (0xa0000) MX[B]
[4] -1 0 0x0000ffff - 0x0000ffff (0x1) IX[B]
[5] -1 0 0x00000000 - 0x00000000 (0x1) IX[B]
(II) LoadModule: "extmod"
(II) Loading /usr/lib/xorg/modules/extensions//libextmod.so
(II) Module extmod: vendor="X.Org Foundation"
compiled for 1.5.3, module version = 1.0.0
Module class: X.Org Server Extension
ABI class: X.Org Server Extension, version 1.1
(II) Loading extension SELinux
(II) Loading extension SHAPE
(II) Loading extension MIT-SUNDRY-NONSTANDARD
(II) Loading extension BIG-REQUESTS
(II) Loading extension SYNC
(II) Loading extension MIT-SCREEN-SAVER
(II) Loading extension XC-MISC
(II) Loading extension XFree86-VidModeExtension
(II) Loading extension XFree86-Misc
(II) Loading extension XFree86-DGA
(II) Loading extension DPMS
(II) Loading extension TOG-CUP
(II) Loading extension Extended-Visual-Information
(II) Loading extension XVideo
(II) Loading extension XVideo-MotionCompensation
(II) Loading extension X-Resource
(II) LoadModule: "dbe"
(II) Loading /usr/lib/xorg/modules/extensions//libdbe.so
(II) Module dbe: vendor="X.Org Foundation"
compiled for 1.5.3, module version = 1.0.0
Module class: X.Org Server Extension
ABI class: X.Org Server Extension, version 1.1
(II) Loading extension DOUBLE-BUFFER
(II) LoadModule: "glx"
(II) Loading /usr/lib/xorg/modules/extensions//libglx.so
(II) Module glx: vendor="X.Org Foundation"
compiled for 1.5.3, module version = 1.0.0
ABI class: X.Org Server Extension, version 1.1
(**) AIGLX enabled
(**) Exporting typical set of GLX visuals
(II) Loading extension GLX
(II) LoadModule: "freetype"
(II) Loading /usr/lib/xorg/modules/fonts//libfreetype.so
(II) Module freetype: vendor="X.Org Foundation & the After X-TT Project"
compiled for 1.5.3, module version = 2.1.0
Module class: X.Org Font Renderer
ABI class: X.Org Font Renderer, version 0.6
(II) Loading font FreeType
(II) LoadModule: "dri"
(II) Loading /usr/lib/xorg/modules/extensions//libdri.so
(II) Module dri: vendor="X.Org Foundation"
compiled for 1.5.3, module version = 1.0.0
ABI class: X.Org Server Extension, version 1.1
(II) Loading extension XFree86-DRI
(II) LoadModule: "vesa"
(II) Loading /usr/lib/xorg/modules/drivers//vesa_drv.so
(II) Module vesa: vendor="X.Org Foundation"
compiled for 1.4.99.905, module version = 1.3.0
Module class: X.Org Video Driver
ABI class: X.Org Video Driver, version 4.1
(II) VESA: driver for VESA chipsets: vesa
(II) Primary Device is: PCI [EMAIL PROTECTED]:00:0
(II) resource ranges after probing:
[0] -1 0 0xffffffff - 0xffffffff (0x1) MX[B]
[1] -1 0 0x000f0000 - 0x000fffff (0x10000) MX[B]
[2] -1 0 0x000c0000 - 0x000effff (0x30000) MX[B]
[3] -1 0 0x00000000 - 0x0009ffff (0xa0000) MX[B]
[4] -1 0 0x0000ffff - 0x0000ffff (0x1) IX[B]
[5] -1 0 0x00000000 - 0x00000000 (0x1) IX[B]
(II) Loading sub module "vbe"
(II) LoadModule: "vbe"
(II) Loading /usr/lib/xorg/modules//libvbe.so
(II) Module vbe: vendor="X.Org Foundation"
compiled for 1.5.3, module version = 1.1.0
ABI class: X.Org Video Driver, version 4.1
(II) Loading sub module "int10"
(II) LoadModule: "int10"
(II) Loading /usr/lib/xorg/modules//libint10.so
(II) Module int10: vendor="X.Org Foundation"
compiled for 1.5.3, module version = 1.0.0
ABI class: X.Org Video Driver, version 4.1
(II) VESA(0): initializing int10
_______________________________________________
xorg mailing list
[email protected]
http://lists.freedesktop.org/mailman/listinfo/xorg
