On 24.04.2023 16:30, Juergen Gross wrote:
> --- a/xen/arch/x86/Makefile
> +++ b/xen/arch/x86/Makefile
> @@ -226,6 +226,9 @@ endif
> $(@D)/.$(@F).1r.o $(@D)/.$(@F).1s.o $(orphan-handling-y)
> $(note_file_option) -o $@
> $(NM) -pa --format=sysv $(@D)/$(@F) \
> | $(objtree)/tools/symbols --all-symbols --xensyms --sysv
> --sort >$(@D)/$(@F).map
> +ifeq ($(CONFIG_DEBUG_INFO),y)
> + $(if $(filter --strip-debug,$(EFI_LDFLAGS)),:,$(OBJCOPY) -O
> elf64-x86-64 $@ [email protected])
This only addresses one of the two earlier raised aspects, as you didn't
use what I proposed:
$(if $(filter --strip-debug,$(EFI_LDFLAGS)),:)$(OBJCOPY) -O
elf64-x86-64 $@ [email protected]
Quite possibly because there was a blank missing in there, to separate
the colon from $(OBJCOPY). Preferably with the adjustment (which I'd
be fine doing while committing, as long as you're okay)
Reviewed-by: Jan Beulich <[email protected]>
To also mention what we have just discussed: Since we're talking about
duplicating over 30Mb of data (at least according to my build), an
option is going to be to then strip debug info off of xen.efi itself,
getting its size into reasonable range again.
Jan
